DM-QMC does not magnetize the entire die, the magnetic flux penetrates the die only 20mm deep.The die face cannot become magnetized, allowing for scrap removal, and proper die operation without interference.In a few seconds with the simple pressing of a button, it is possible to clamp or unclamp the die in complete safety. Even during a power failure, the system remains operative, with constant clamping force. It is in the heart of this change with no hidden time to fix clamps, make adjustments or test between 2 production batches. Made up of 2 magnetic modules, it's easy to install, and integrate into the existing machine and controls.DM-QMC is easy to install. Using bolts to mount magnetic plates to existing T-slots or tapped holes. Its modularity allows adaptability for any need. No modifications to the press are required. Bigger dies can be used in smaller presses.
quick mould clamping magnetic for 1500Tstamping presses

One operator, with no tools, can operate all the die-clamping easily and in total safety, while

staying outside the press. Load the die, close the press and press the button for the upper,

then the lower.DM-QMC is not affected by electrical breakdowns. The die will stay in position even without power supply, with the same strength indefinitely. This uniform clamping force allows repeatability and constant quality of the stamping process by eliminating any flexing of die shoe.

DM-QMC is suitable for any die of any shape and size, without modification. Die standardization is not necessary, saving engineering time and overall cost. If the die is not magnetic or when the contact surface die/magnet is too small, the die can be equipped with a common steel backplate

DM-QMC control interface is small and installs easily The system uses several safety devices to avoid accidental mag or de-mag:

- The buttons must be activated simultaneously (SAFE function).

- The interlock key to prevent mag/demag by unauthorized personnel.

- Bottom dead center channel enable.